Aver iMatrix Manual do Utilizador

Remote iMatrix User Manual Oct.2008

7 Name Function (1) Exit Call up the Logout dialog box. In the logout dialog box, you may do the following: - Click Exit to close the iMatrix p

8 3.2.1 Using Monitor Controller User can use Monitor Controller to switch different monitor set for monitoring and add/delete the channel in monit

9 [Step1] Select the montior[Step2] Click to expand the cameras[Step3] Drag the camera to the blank block[Step5] Click to close the sub window

10 3.2.2 Familiarizing the Buttons in PTZ Camera Controller (1)(11)(2)(3)(4)(5)(6)(7)(8) (9) (10) Name Function (1) Close Exit PTZ camera control

11 Chapter 4 Customizing the iMatrix System In the iMatrix application, click the button to customize the iMatrix system. In the Authorization d

12 (3) Screen Setting Enable/disable monitor for monitoring. Only the monitors that connect with iMatrix system are available for enable/disable. (4)

13 7. Click OK to accept the new setting and Cancel to exit without saving the new setting. 8. And then, the iMatrix system will try to connect wit

14 5. After the Monitor set has been created, select the DVR server. And then the camera channels of the DVR server will display on the Camera Sele

15 9. Click OK to save the setup. To exit without saving, click Cancel. 10. To delete the monitor set, select the monitor set in Monitor Select wind

16 4.4 User Setting iMatrix supports 256 user account that includes operator and administrator account. 14. Click Setup. 15. In the Authorization di

DISCLAIMER No warranty or representation, either expressed or implied, is made with respect to the contents of this documentation, its quality, perf

17 Chapter 5 Using the Playback Function User can playback recorded video from the remote side of the DVR server. i - Playback function must be ena

18 Button Function Select recorded vide to playback from remote DVR server hard disk. Select the date on the calendar and the time from 00 to 23 to

TABLE OF CONTENTS CHAPTER 1 INTRODUCTION...1 1.1 Dual Monitors Setting .

1 Chapter 1 Introduction The AVerMedia® iMatrix is a monitoring system that enables user to monitor DVR servers through an internet connection. iMa

2 2. There are two modes to select ─ Basic and Advanced. 3. If user selected Basic mode, press the Quick Settings tab. Then select the Select a

3 5. If user selected the Advanced mode, click the View button. 6. In Display Manager, right click on the second Display on the right side and sel

4 1.1.2 Graphic card with NVIDIA chipset 1. Click the NVIDIA nView, and select the Dualview mode. 2. Adjust each monitor resolution to 1024x768 、

5 Chapter 2 Software Installation This chapter describes how to install the iMatrix software. Before installing the software, make sure the Window

6 Chapter 3 Using the iMatrix 3.1 Running the iMatrix Software To run the application, double-click on your PC desktop or click Start > Progr